Several points needing attention in the use of reinforced concrete cutting wire saw

Several points needing attention in the use of reinforced concrete wire saw

Diamond wire saws, after all, is a construction project must have to pay attention to many matters, it is first necessary to maintain reinforced cutting machine working in normal and stable environment, so before use should conduct a comprehensive inspection of machinery to ensure the door device is safe and effective, selection of saw blade meets the requirements are correctly installed and so on. Then it is in the operation of the matter, when the machine is started, to check and confirm the operation direction of the saw blade is correct, when everything is in the normal state of operation can be carried out.

The last few important is in the work, when the workpiece impact, beating and abnormal sound, should immediately stop the inspection, troubleshooting, after the side can continue to work. Steel reinforced concrete cutting is strictly prohibited in the operation of the inspection, maintenance of the parts. Debris saw table and component in the kerf should be promptly removed by using special tools, do not use hand picked up or wiping. After the operation, should be cleaning the body, wipe the blade, the remaining water discharge tank, recover the cable, and stored in dry and ventilated place. Long term use of the machinery, in addition to the necessary mechanical part of the maintenance of maintenance, you must measure the motor insulation resistance, qualified rear can be used.